Raspberry Pi 3 Quick start

Defaults: pi, raspberry

How to change

After flashing add to SD_CARD_BOOT_PART/config.txt

# Enable UART
enable_uart=1

OR in partition directory run

echo "# Enable UART" >> ./config.txt
echo "enable_uart=1" >> ./config.txt

Step A

Login into RPI

Step B

sudo etc/dhcpcd.conf

Step C

Add this (with a respective modification):

interface eth0
 
static ip_address=192.168.210.10/24
static routers=192.168.210.1
static domain_name_servers=192.168.210.1
 
interface wlan0
 
static ip_address=192.168.1.210/24
static routers=192.168.1.1
static domain_name_servers=192.168.1.1